| |
 |
 |
This convenient oil-based solvent saves time and money
for general service and repair shops. It will prevent
contaminating new or rebuilt transmissions you install.
To use instead of an expensive cooling system
flushing machine to clean system and prevent cross
contamination.
FOR PEOPLE WHO DON'T HAVE A
DEDICATED COOLING LINE FLUSHER
A three in one product
The flush can is used to prevent transmission
contamination by removing and eliminating contaminants
such as grease, dirt, sludge, grime and metal shavings
in transmission cooling systems and lines, without
leaving any water or soapy residue in the system. It
also cleans electric parts, wire harnesses, etc. leaving
a thin layer of dielectric protectant. |
|
has three uses in one:
|
(wire harnesses & solenoids), electronic engine
connections (computers, sensors & wiring)
|
|
|
1. Line Flush Cleaner
|
2. Electronic Transmission
Cleaner |
3. Dielectric Protectant
|
Benefits
- Leaves no soapy residue
- Contains no water
- Prevents contamination
- Prevents costly comebacks
- Contains no ozone
depleting chemicals or CFCs
- Contains no chlorinated
solvents
- Easy to Use
There have been many debates
about the use of water based detergent cleaners (soaps)
and oil based solvent cleaners. Water based transmission
cleaners have high detergent and dispersant levels, and
once flushed through the system leave behind a film of
the detergents, water, dispersant and/or ATF emulsion on
the walls of the tubing. The water and chemicals
remaining, which are not good for your transmission,
will become part of the new ATF when the transmission is
re-installed. Using an oil based cleaning method makes
sense; the technician can ensure that the new ATF stays
dry and that the transmission is reassembled to last.
Directions for Use
For Line Flush Cleaner: Attach
connector to transmission feed line. Next, attach hose
to transmission return line to collect flush and residue
in a waste container. Hold can upright and actuate.
Flush until clear. For best results use entire content
of can per installation. Then turn can upside down and
continue cleaning with air only.
For Wire Harness Cleaner: Cut off hose
to appropriate length to direct the stream. Spray over
dirty depowered 6-12 volt electrical components.
For Dielectric Protectant: Allow
cleaned components to dry before repowering. |
|
